RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Éric F14
Showing results 1 to 12 of 12
Search took 0.02 seconds.
Forum: RC Jets
07-18-2015, 11:31 PM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Ok, do you used the delta mixing inside the I...

Ok, do you used the delta mixing inside the I Gyro
what is your set up, gyro value, only used in swept position
I have a powerbox royal SRS, it is the same as I gyro

Eric
Forum: RC Jets
07-18-2015, 11:26 AM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Pneumatic system installed by skymasterjet...

Pneumatic system installed by skymasterjet insiste the jet
I have a lot off leaks

Eric
Forum: RC Jets
07-18-2015, 10:57 AM
Replies: 1,726
Views: 435,560
Posted By Éric F14

For the moment I flight without gyro, even with...

For the moment I flight without gyro, even with wing back,, I think in this position the aileron course is to important.
i made some roll and the rotation is to fast
about the gear, I have no...
Forum: RC Jets
07-18-2015, 09:08 AM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Hello nice flight, did you used gyro with the...

Hello
nice flight, did you used gyro with the wings back
I have 20 flights with my model, very good flight characteristics...
Forum: RC Jets
03-29-2015, 12:36 AM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Hello an other thing, be careful about air...

Hello

an other thing, be careful about air durit on gear cylinders, some of them can remove with pressure
if your gear is white paint, skymaster put painting on the connections and it is...
Forum: RC Jets
03-28-2015, 08:55 AM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Hello, the value is near 3 Amps equipment: 2...

Hello,
the value is near 3 Amps
equipment: 2 sequencers, 7 valves, PB royal SRS, 14 servos, CB speed sensor, 2 CB engine telemetry

regards

Eric
Forum: RC Jets
03-21-2015, 10:06 AM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Have you installed a powerbox inside your model,...

Have you installed a powerbox inside your model, if yes what is the Amps value with all on?
i will Check mine end of n'est week
for information I used lock system for the gear when radio Switch of...
Forum: RC Jets
03-10-2015, 11:36 PM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Hello, 115 mm each side for me could you Tell...

Hello, 115 mm each side for me
could you Tell the main wheel tyre diameter with air inside?
in mine F14 the maximum is 120 mm, after the tyre touch the door gear cylinder
is it the same thing for...
Forum: RC Jets
02-19-2015, 12:24 PM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Hi is it necessary to have a specific mix...

Hi

is it necessary to have a specific mix between flaps ans elevator (with full flaps)

Eric
Forum: RC Jets
02-17-2015, 11:27 PM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Your point is directly to the carbon part, So...

Your point is directly to the carbon part, So this i have a valu for 15 mm in front

Eric
Forum: RC Jets
02-17-2015, 10:22 PM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Hi Barry, at that moment, the gravity center...

Hi Barry,

at that moment, the gravity center position is 15 mm in front of the wing carbon part, is it ok

Eric
Forum: RC Jets
02-17-2015, 12:26 PM
Replies: 1,726
Views: 435,560
Posted By Éric F14

Hello, I arrive at the end of the F14 building ...

Hello,
I arrive at the end of the F14 building
could you confirm exactly the position for the gravity center?
have you used the skymasterjet set up?
have you used a solution to avoid a trouble...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.