RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Truckracer
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: Gas Engines
11-01-2019, 04:36 PM
Replies: 30
Views: 4,751
Posted By Truckracer

👍 I understand completely.

👍 I understand completely.
Forum: Gas Engines
10-29-2019, 12:37 PM
Replies: 30
Views: 4,751
Posted By Truckracer

The DLE ignition is an Rcexl ignition. Valley...

The DLE ignition is an Rcexl ignition. Valley View sells Rcexl ignitions. What is the difference?

Other than Rcexl, the other two common ignitions are CH (which also sells Rcexl) and RCAME sold...
Forum: Gas Engines
10-25-2019, 06:35 PM
Replies: 30
Views: 4,751
Posted By Truckracer

Have you tried richening the low speed needle...

Have you tried richening the low speed needle until the engine will transition normally to full throttle. This needle feeds fuel through the whole throttle range.
Forum: Gas Engines
08-20-2019, 07:42 AM
Replies: 30
Views: 4,751
Posted By Truckracer

“Bounty of knowledge”? Not sure where that came...

“Bounty of knowledge”? Not sure where that came from. I agree there is no need for a high speed servo on throttle but what does high torque have to do with the issue? Speed and torque are relative to...
Forum: Gas Engines
08-18-2019, 09:09 AM
Replies: 30
Views: 4,751
Posted By Truckracer

Have you ever removed and inspected the carb,...

Have you ever removed and inspected the carb, throttle plate, shaft and linkage yet?
Forum: Gas Engines
08-17-2019, 05:45 PM
Replies: 30
Views: 4,751
Posted By Truckracer

If you buy a servo, please don’t buy the 5645....

If you buy a servo, please don’t buy the 5645. Hitec has updated that servo to the D645mw that offers much better performance compared to the 5645. Frankly the 5645 was never a very good servo as its...
Forum: Gas Engines
08-17-2019, 01:48 PM
Replies: 30
Views: 4,751
Posted By Truckracer

Some analog servos have been known to have a mind...

Some analog servos have been known to have a mind of their own when mounted near ignition boxes. You might consider moving up to something like a Hitec D645 / 625mg for your throttle. Just a few $...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.