RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: mbrennan1
Showing results 1 to 25 of 41
Search took 0.08 seconds.
Forum: Glow Engines
09-04-2009, 09:49 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Can anyone tell me the size of the bolt that holds the jug down on an FA 82a? I lost one and need to find a replacement.
Mike
Forum: Glow Engines
05-19-2009, 05:24 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Thank You! I will go get one.
Forum: Glow Engines
05-19-2009, 01:21 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Can any one tell me what is a good 3-D prop for the saito 82. I run a 13x8 on my pattern plane with a 82. Would I use a 14x4, 15x4, maybe a 15x5?? I have a OMP profile yak that I put a Saito 82 on....
Forum: Glow Engines
04-06-2009, 10:15 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Where can I find castor oil? Is it the same stuff at my local drug store?
Forum: Glow Engines
03-20-2009, 11:57 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I own 6 Saito's, love them all!! The LSN is set a few turns below flush, except my 150. I bought it NIB a while back. I know the engine is at least 6 years old. I have around a gallon of Wildcat 15...
Forum: Glow Engines
03-14-2009, 01:47 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I will have to start a list!!!!!!!!

Mike
Forum: Glow Engines
03-14-2009, 01:20 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I guess I'll have to break down and buy a whole set. Shipping will cost more than the screws. Oh wellgotta have it!!
Thanks
Mike
Forum: Glow Engines
03-14-2009, 11:00 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I am up to 6 Saito's . I have a 180, 150, 125, 91, and 2- 82's. I love them all. I do have a question. I replaced the bearings in one of my 82's. Somehow I lost one of the 4 screws that that holds...
Forum: Glow Engines
02-09-2009, 04:45 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Thanks, I will try that. It does not stick that bad, just enough to get my attention. As far as the screw, there is one in the opposite side(180 degrees)bottom, but not one one top.
Forum: Glow Engines
02-09-2009, 04:08 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I've been following this Forum for over a year and have found it very helpful. Hopefully you can help me again. I just bought a slightly used 150. Seems to run fine, BUT, the throttle arm is very...
Forum: Glow Engines
11-30-2008, 11:55 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Where is a good place to order bearings from? I want to replace the ones in my 180 and 150. Is it worth the extra money for ceramic? I noticed there are several different types to choose from. What...
Forum: Glow Engines
11-23-2008, 10:55 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I have a Saito 150 looking for a new home. I was looking at the Extreme Flight Yak 54-74". Anyone have any experience with this set-up? I am afraid of under powering this plane. Any other...
Forum: Glow Engines
09-22-2008, 10:51 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

When changeing the bearings in my 125, I starterd disassembly, at what point do I pull off the front hub and do I need to pull the cam out??? I will wait until I get a reply. All I have out so far is...
Forum: Glow Engines
09-21-2008, 06:40 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Thanks for all the info. I am sure it will go fine. I just don't want to ruin anything.
Thamks again, I'll report on how it went.
Forum: Glow Engines
09-21-2008, 03:29 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Me again. Does anyone know of any web pages I can refer to for detailed instructions on how to change the bearings in my 125? I have looked and have not had much luck. My bearings should be here...
Forum: Glow Engines
09-21-2008, 06:04 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I am going to change the bearings in my Saito 125. I have a gear puller for the hub removal. Is there any hints or tricks I should know about to make this a successful task? This will be my first...
Forum: Glow Engines
09-18-2008, 04:34 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Thanks Ken. I ordered the bearings last night, and not from horizon. Thanks for the info. Now I am going to dig back on this thread for some good instructions on changing them.
Forum: Glow Engines
09-17-2008, 08:39 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Can someone please give me the proper part #'s from Horizon for replacement bearings for a FA125? The code for that engine is AG?? and I can not find bearings for code AG.
Thanks in advance for...
Forum: Glow Engines
06-16-2008, 06:37 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I have nicked the tips on a few props. I shave a little off the opposite side and re-balance. I am not sure if this is safe or not, but I have done it. I have never re-used one that was missing 1/2"....
Forum: Glow Engines
04-28-2008, 04:55 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I was having the same problem starting my 180. I went to Batteries Plus and bought an 11 mah battery that still fit into my field box. It was not much bigger than my 7 mah battery. It cost me 29.00....
Forum: Glow Engines
04-27-2008, 05:03 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I saved it. Maybe some rainy day I will start rebuilding it.
Forum: Glow Engines
04-27-2008, 08:18 AM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Here are some pics of my FUN day at the field. The Saito 82 was buried in the mud. It broke off a valve cover, lost push rod, broke rocker arm mount, and dented intake tube. I sent it of to Horizon...
Forum: Glow Engines
04-26-2008, 10:12 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

Ok, I uploaded pics, click OK, then goes back to a new posts screen. Theb what do I DO??
Forum: Glow Engines
04-26-2008, 08:54 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I wanted to show some pics of my mishap at the field. How do add pics????

Club Saito Member #591
Forum: Glow Engines
04-23-2008, 08:46 PM
Replies: 54,816
Views: 5,386,971
Posted By mbrennan1

RE: Welcome to Club SAITO !

I have a Saito 82. It was installed in a pattern plane, Lark 70, that crashed on it's third flight. Plane was destroyed. Motor suffered a lot of damage. Needs new head, intake tube. push rod, and...
Showing results 1 to 25 of 41
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.