RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: OldRookie
Showing results 1 to 4 of 4
Search took 0.09 seconds.
Forum: Glow Engines
09-22-2008, 01:13 PM
Replies: 54,701
Views: 5,315,496
Posted By OldRookie

RE: Welcome to Club SAITO !

What are you doing in the third picture?

When I pulled the prop washer off on my100, the collet came out with it.

Greg
Forum: Glow Engines
08-30-2008, 09:41 PM
Replies: 54,701
Views: 5,315,496
Posted By OldRookie

RE: Welcome to Club SAITO !

My Saito 100FA recently managed to grind up the ball cage from the rear bearing. About 20 gal through this engine.
I saw some rust pits in pieces of the ball cage. I run only 20% nitro 20% oil in...
Forum: Glow Engines
08-06-2008, 06:00 PM
Replies: 54,701
Views: 5,315,496
Posted By OldRookie

RE: Welcome to Club SAITO !

Thanks for the replies.

It is about what I thought, but seeing as I haven't worked on a Saito yet, I figured I would ask if there were any quirks with Saito.

Greg
Forum: Glow Engines
08-06-2008, 01:14 PM
Replies: 54,701
Views: 5,315,496
Posted By OldRookie

RE: Welcome to Club SAITO !

I am in the process of re-assembling my Saito 100.
I had to make a plate to pull the prop driver nut and taper collet.
I also made a pin to locate the timing mark in the correct position when the...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.